UWE slewing ring installation munual

1.Slewing Ring Identification
If UWE finished bearings, all of these are accompanied by UWE signage. The signage is located near the soft belt (ball holes)of bearing raceway or according to user’s requirements . Signage on the identification code (Product Code) is the only available queries.
2.Important marker
(1)There is a raceway hardening soft belt mark on the outer ring and inner ring in the finished bearing.Soft position is on ball filling hole without marking if bearing has ball hole ring; marking "small hole" or compliance with "S" corresponding to hardened soft belt if there is no ball hole ring. Soft belt and marker can be determined according to user requirements.
(2)For toothed products, there are three biggest teeth relative to the raceway beating, located smallest (the tooth), maximum (external gear) diameters on the beating circle, and has a circular hole marker on the  tooth tip surface. Painting with red or green on the top of tooth.
3.Check before assembly
(1)Carefully open the package, not to damage the bearing surfaces and seals, especially bearing end faces, otherwise it will affect the quality of the bearing assembly. If you find the hole plugs shedding, will require detailed examination, cleaning, must ensure no foreign object into the lubrication raceway.
(2)Check and make sure that the installing bearing is matching your host.
(3)Confirm that the installing bearing has no shock and damage during transport.
(4)Check the seal is not broken.
(5)Check the hole location and ensure that no foreign object into the lubrication raceway.
(6)Check the beating tooth maximum point whether clear.
(7)Check whether the location marker on the soft belt clear.
(8)Check the anticorrosive coating surface is not damaged.
More information about slewing ring, please visit www.uwe-bearing.com or email sales@uwe-bearing.com